門幅計算ツール

A gate width calculator solves a narrow but easy to get wrong problem: the opening between two posts and the panel that swings inside that opening are not the same number, and the gap between them is small enough to ignore by accident but large enough to ruin a build if it is ignored. The opening is fixed the moment the posts are set in concrete and cannot be changed without resetting a post. The panel has to be built a little smaller than that opening on purpose, with a clearance gap on each side, so the leaf can swing freely without dragging on either post as the wood or vinyl moves with the seasons. This calculator takes the clear opening and the clearance you want per side and returns the exact panel width, in both inches and feet, so there is no guessing at the bench or the shop, and no need to redo a cut because the panel came out a half inch too wide to swing.

The formula itself is simple once it is laid out clearly: multiply the opening in feet by 12 to get inches, then subtract the clearance per side times two, keeping the units consistent the whole way through. A 4 foot opening with an inch of clearance on each side comes to 46 inches, or 3.83 feet, which is 48 inches minus 2 total inches of clearance. The part that trips people up is the direction of the subtraction. The clearance comes off the opening to get the panel size, not the other way around, because the panel has to fit and swing inside the post-to-post gap rather than cover it from the outside. A panel built wider than the opening by adding the clearance instead of subtracting it simply will not fit between the posts, and that mistake is far more common on a first build than it sounds, especially when the opening is read off a tape measure quickly and the clearance is added out of habit rather than worked through step by step.

This math only covers a single swinging leaf. Wide drive openings are usually split into two leaves that meet near the center with their own meeting gap, and that changes the per-leaf width in a way this calculator does not handle directly. For that case, the double gate calculator covers the center meeting gap and the hinge clearance on each outer post separately, since a double gate has three clearance points instead of two. Once the panel width from either calculator is settled, the posts on each side need to be sized for the load that leaf is going to put on them: the fence gate calculator covers the opening and hardware decisions together, and the fence post calculator and post concrete calculator handle the post sizing and the concrete volume for a gate post hole, which is typically deeper and wider than a standard line post hole because of the leverage a swinging gate puts on it.

The default clearance in this calculator is 1 inch per side, which is a reasonable starting point for most residential wood and vinyl gates, but it is not a fixed rule. Heavier leaves, gate posts that are slightly out of plumb, long spans, or a concrete sill the gate has to clear can all call for more room on one or both sides, and the calculator accepts whatever clearance figure you enter rather than locking you into the default. It is also worth keeping the clearance even on both the hinge side and the latch side rather than stacking it all on one edge for convenience. A build that skips clearance on the latch side to save a fraction of an inch will bind at the latch the first time the wood absorbs moisture, even if the hinge side swings freely. Wider panels also carry more weight onto the hinge post, which is part of why wide drive openings move to a double leaf and upsized posts rather than a single oversized gate, a point covered in the gate hardware and framing guide along with the hardware ratings that go with a heavier leaf. For material and cost planning once the gate panel and posts are both sized, the fence cost calculator rolls the gate into the rest of the fence budget, and anyone building the gate into a matching privacy run can check panel and picket sizing at the privacy fence calculator. The full set of gate sizing tools, including the post and double gate calculators, sits together under the gate calculators category for anyone working through a gate build from opening to hardware in one pass, and the fence materials guide is a useful reference for matching the gate frame material to whatever the fence panels on either side are built from.