支柱間隔計算ツール

Dividing a fence run by a fixed spacing number almost never comes out even, and the leftover is what causes the familiar problem of a short, awkward panel at the end of an otherwise uniform run. This calculator solves for equal sections instead of fixed spacing: it takes the total run length and a maximum spacing you choose, works out how many equal sections the run needs to stay under that maximum, and then divides the run evenly across that many sections so every span, including the last one, comes out the same length. The result reads in on-center terms, measured from the center of one post to the center of the next, which is the standard convention lumber and panel manufacturers also build to.

Maximum spacing is not interchangeable across materials, and treating it as one universal number is a common mistake. Wood privacy fencing is commonly capped around 8 feet on center before a 2x4 backer rail starts sagging under picket weight in hot weather, while vinyl panels are usually manufactured for one exact spacing, 6 or 8 feet, with no flexibility to stretch a panel system beyond its molded width. High-wind sites push the other direction: open rural or coastal exposure is a common reason to tighten spacing to 6 feet on center and step up to larger posts, since wind load on a solid privacy fence scales with the unsupported span between posts. The post spacing guide lays out these material-specific ranges in more detail.

Two site conditions change the spacing math beyond the basic run length. A gate opening has to be subtracted from the total boundary length before the remaining fence runs are divided into equal sections, since the gate itself is not a post-spacing problem, it is a fixed width that the fence sections have to work around. Slope is the other factor: spacing is measured horizontally along a level string line, so the actual sloped distance between two posts on a hill will run slightly longer than the horizontal spacing number suggests, which matters when you are ordering rail stock sized to the on-center distance. The post count guide and the wood fence installation guide both cover these adjustments as part of a full layout, not as an afterthought.

Equal spacing from this calculator feeds directly into two other counts. The fence post calculator turns the section count this page produces into a total post count including corners and ends, and the fence rail calculator uses the same on-center spacing to size rail stock per section once you know how many equal spans the run is divided into. Post length and depth are separate decisions from spacing itself; the fence post length calculator and the fence post hole calculator handle those once your spacing plan is set. For a run broken into distinct measured segments rather than one continuous line, the fence section calculator is the better starting point, and the full set of post and footing tools lives under the foundation calculators category.

Fractional spacing numbers, like the 7.73 feet that an 85 foot run divided into 11 equal sections produces, are not a rounding inconvenience to work around, they are the actual on-center distance to mark and build to. Converting a decimal foot figure to feet and inches before marking post locations on the ground avoids the error of rounding each post location independently, which compounds across a long run and can leave the last section noticeably different from the others even though the calculator's math assumed every section was identical. Marking all post centers from a single string line or chalk line, measured from one fixed end of the run rather than post to post sequentially, is the more reliable way to keep that equal spacing accurate over a long fence, since sequential measurement lets small errors accumulate from one post to the next. Equal spacing also simplifies material ordering beyond just posts: rails cut to one consistent length instead of a mix of custom sizes reduce both waste and the chance of installing the wrong length rail in the wrong bay. For runs with multiple corners, each straight segment between corners should be treated as its own independent spacing calculation, since forcing one spacing number across a run with several different segment lengths usually reintroduces the uneven end-panel problem this calculator exists to avoid in the first place. Post diameter itself can also nudge the practical spacing slightly: a true on-center measurement from a 4x4 post and from a 6x6 post at the same stated spacing leaves a different clear gap between the faces of adjacent posts, which matters more for board-on-board or shadowbox styles where picket overlap depends on that clear gap than it does for open styles like split rail where the gap is simply open space.